Posts Tagged ‘construction and repair’

Market Indicators Forestry

Tuesday, August 11th, 2015

Tags:
Posted in General | Comments Off on Market Indicators Forestry

According to fao, demand in the global market, established on the forest products industry: – lumber, dictated by the level of income. In addition to the demand for wood also takes into account the factor of environmental requirements and demographic growth of the population. For example, population growth in the period from 60 to 90, 20 th century led to an increase in consumption of forest products like lumber and wood products used as fuel. On Market Indicators Forestry also has a direct impact of seasonality. In 2000, winter and spring buying lumber were low, as expected price declines for lumber closer to fall, but summer, when whose construction begins, leading to an early decline in prices for lumber. To read more click here: Ben Silbermann. The presence of multiple factors that influence the development of forest industries (lumber), makes the analysis difficult task, so the timber trade in goods is a very serious and the mobile system.

Forest industry – a market that provides sawn timber and domestic needs States, of course part of the production is exported to other countries, but the timber trade between the continents, is a small fraction of the total turnover of the forest industry. This happens mostly because of the massiveness forest products. Therefore, the price of standard lumber, wood boards, ultimately, because transport costs, increase sharply, making imports more expensive domestic wood. For order that would make timber and timber for export must be compensated for transportation costs. Compensate for their possible through cheap raw materials or through lower production costs.

The Assumption

Saturday, September 20th, 2014

Tags:
Posted in General | Comments Off on The Assumption

The fact that the plate at this point there is a special hole for the pipe. And the builders of his post-heating close up. So I was so – from above a small layer of plaster, and under it – different stones, ie, construction debris, which the builders probably swept into a hole with a broom. These stones I pulled his hands up until they dragged (to break the neighbors I did not, but maybe this is worth it to do). If you would like to know more about Santie Botha, then click here. Furthermore, primed poured all plitonitom (plaster). I remember in one room (for two holes for pipes) took something around 4 kg plitonita.

You can imagine what it was voluminous and deep holes. 3) nadpolnye seams. This is a place under the baseboards, where the floor plate closer to the wall. It all started with that in the winter, we noticed that out of the plinth is the frosty air. When near the study found that under the thin and often broken plaster has large cavity, which is quite possible to stick a pencil, and in doing so he did not make it to the wall.

Of these cavities and the incoming cold fresh air. At first, I even had the assumption that it is a hole right through, ie on the street. But from the street, I saw nothing. These cavities are often spread not only inwards, but also down. I think they were good . and because of their terminations as needed for insulation and soundproofing. Closed up all the foam and topped again plitonitom.

Wallpaper

Friday, February 3rd, 2012

Tags:
Posted in General | Comments Off on Wallpaper

To reduce the suction capacity of the surface and creating her adhesive film surface glued with glue or flour paste cmc with the addition of animal glue. Recommended prokleivat warm flour paste, which is easily absorbed into the surface. Paste is applied with a brush and centrifugal good shade. In the case of dry glue industrial surface previously primed with the same adhesive, but thinner in the ratio indicated on the label. To keep pace with wallpaper on the surface adhesively bonded sheets of porous paper (you can use old newspapers). Paper, a more porous material, thoroughly soaked with paste and firmly retained on the surface, while aligning it.

Under simple and the average density of wallpaper paper glued lap, and by stamping and dense – back to back. Work on the adhesion of paper perform two painter. One of them plaster paste and stacked in a pile on the table sheets and feeds them to the second worker. Having taken a piece of paper, the second working sticks it to the surface and gently smooths dry cloth or brush to it had no wrinkles and bumps. According to the dried glue paper wallpaper. In the preparation of gypsum concrete and surfaces for wallpaper pasting paper perform the same operations as in the preparation of plaster, with the exception of pasting the paper surface. Preparation of surfaces, coated with sheets of drywall The surface of the drywall careful not to break the board, clear of spray putty. Seams between sheets of palms and after drying of bedding grind.